Another k40 DSP conversion complete!
Posted: Thu Feb 21, 2013 5:30 am
My z axis table arrived a couple of days ago so I finally got my k40 all finished and buttoned up last night. Even engraved a few things.
I will say for the most part the entire process was straightforward and I'm thrilled with the results.
Now I just need to figure out all the power and speed settings for the materials I use. I also need to get my focal length perfected but I think I'm close there too.
I also wanted to thank Marco for all his help.
I will say for the most part the entire process was straightforward and I'm thrilled with the results.
Now I just need to figure out all the power and speed settings for the materials I use. I also need to get my focal length perfected but I think I'm close there too.
I also wanted to thank Marco for all his help.