Page 1 of 1

can't save user parameters

Posted: Thu Dec 06, 2012 1:54 am
by Jacala
Hello!

I'm having a weird problem! I can not save my user parameters.

I have a new stronger steppermotor and so i want to increase the engraving_acc. but for some reason when I insert a new value it saves (no error, just like normal) but when I check "Read" to see the info in the DSP it changes back to the previous value.

I can change and save Manufacturer value's so thats a bit weard.

Who can give me some advice?

Re: can't save user parameters

Posted: Thu Dec 06, 2012 2:15 am
by Jacala
here some specs:

Lasercad 6.27
main board: 7.12.09.21
LCD board: 5.12.02.29


.....


And I found the problem. Manufacture parameters was set to a low value....... So that overrides the use specs.

Sorry, hopefully someone can use this info!