Page 1 of 1
JLD-7100 with K type thermo couple?
Posted: Sat Nov 03, 2012 1:29 pm
by jkarpy
Hi Marco,
I am using the ETC-CB-K1M K type thermo couple. As I understand it , I need to add a resistor between pin 7 and 8. What value resistor is required?
Re: JLD-7100 with K type thermo couple?
Posted: Sat Nov 03, 2012 2:49 pm
by Tech_Marco
It's not a resistor. It's for PT100, 3 wires type probe (red label). I believe that my manual has mentioned about it
If you're K type probe, use #9 & #10 without #9.
Marco
Re: JLD-7100 with K type thermo couple?
Posted: Sat Nov 03, 2012 5:17 pm
by jkarpy
Tech_Marco wrote:It's not a resistor. It's for PT100, 3 wires type probe (red label). I believe that my manual has mentioned about it
If you're K type probe, use #9 & #10 without #9.
Marco
I did not get a manual. Where can I download it?
Thanks