Lightobject.com Support Forum

Specification

Dual output SSR(6V, 40mA),
Relay(3A 120V AC)
I'm confused on how to wire and enable the rellay (3a 120v AC) option.

The manual didn't help me any, 3~100 second number value???

should it be done with J1 or J2 output's ??

any help would be nice.

Thank you

I looked at the manual, and with just a brief perusal, I couldn't figure it out either. I just don't know what the time interval does. It's obvious that the unit can be programmed to use the relays, but anything after that is a mystery. Sorry.

richiem wrote:I looked at the manual, and with just a brief perusal, I couldn't figure it out either. I just don't know what the time interval does. It's obvious that the unit can be programmed to use the relays, but anything after that is a mystery. Sorry.

What I did was to use the SSR to switch on/off a double pole mercury relay for my 220V kiln. Work just as well. Thanks for the reply.