Lightobject.com Support Forum

Hey guys, well, got my Y and X stages complete today and moving!

I have strapped on another laser module I had laying around (Luckily it's one of my hobbies ), and noticed that my output is upside down and mirrored vertically. This is how I have my machine configured:

This is how I've configured my workspace and limit switches:



This is the result. The red dot is the origin (X-, Y-):



And my LaserCad setup:



Can anyone tell me how to flip the image up the right way and also mirror it vertically in my settings?

Regards,
Dan

Ooops, turns out I had the origin set to left top instead of left bottom, that fixed it! Was thinking it was a machine issue for some reason.

Dan