Lightobject.com Support Forum

New LaserCad V5.87 just completedI'll post it soon. Now it allow you to use LC to read your current location and then you can set a new location you want the machine to move toward to by enter X,Y number. Plus, if fix some bugs; single chars issue and naming file issue.


Marco

Hey Marco,

Great, moving to desired position is indeed great, if you fill in the new position is it then the absolute position? or is is plus the old position.

e.g. the previous position is x 200 and y 225, i enter new position x 300 and y 400 , is that then the new position? , or is x500 and y625 the new position.

Further by publishing the new software can you also add a list with all bugfixes and new features..?

Thanks
Ruud

There are some bugs found on the V5.87 so I decided not to release it till the programmer fixed it.
It may take a couple more days

The position is in "absolute" position. So it's neither increment or decrement the step but will travel to the true co-ordination.


Marco

Ok, V5.88 was released last night. So, what feature(s) were added and what bug(s) were fixed.

See this: viewtopic.php?f=55&t=1080