Page 1 of 1
My DSP board does not show a ENA connection.
Posted: Wed Feb 08, 2012 11:59 pm
by Howardb
I have setup the whole unit but the stepper will not move and the Drive shows an ENA but the DSP doesn't have it any where? Please advise what to do.
Thank you
Re: My DSP board does not show a ENA connection.
Posted: Fri Feb 17, 2012 11:30 am
by Ruud Hogenberg
Howard,
Not sure what stepper driver you have.
I have puzzled with this too.
Pulse to Pulse
Dir to Dir
5dcVolt to Opto.
ENA = no connections
Regards,
Ruud Hogenberg
www.gippetto.com