Page 2 of 2
Re: OS upgrade error
Posted: Mon Dec 31, 2012 1:11 pm
by Tech_Marco
Steve, check your "PM". File just sent
Let me know if you still have the upgrade problem.
Try to use 1Gb, 2Gb, 4Gb, 8Gb memory stick but stay away from 16Gb. Also, make sure it is formatted to FAT32
Marco
Re: OS upgrade error
Posted: Mon Jan 07, 2013 10:03 am
by SScnc
Got it, Thanks very much Marco, I appreciate it !
Best regards,
Steve
Re: OS upgrade error
Posted: Fri Jan 11, 2013 10:49 am
by SScnc
I have LaserCad v6.27 and just upgraded (or attempted to upgrade) my DSP 2012, I tried v1, v2, v6, v7, v8. The only ones that would load and upgrade were v2 and v6. The memory stick I'm using is FAT32 format but it's only a 256mb but has been working perfect for transferring files.
Below is a pic of my current DSP screen after loading v2 then v6, is v6 high enough to run LaserCAD v6.27 properly ?
Re: OS upgrade error
Posted: Fri Jan 11, 2013 11:45 am
by Tech_Marco
Yes. V6 is your version number so you can't use V7 or V8
Marco
Re: OS upgrade error
Posted: Fri Jan 11, 2013 12:08 pm
by SScnc
Thanks for the fast and helpful reply, as always Marco !
I did a few dimensional test cuts and all turned out perfect, it's nice to finally have PPI too !!! I'll try an engrave file tonight.
Thanks again,
Steve