I have a 40w cheap laser. I installed the AWC608 upgrade using the original laser power supply. The laser will only fire at about 25% of full power. I found what I think is the pinout of the supply (see image). I can wire up a button and a pot and get it fire at full power. Also after a few test runs the display text has gotten very dim. Maybe an controller issue? Please advise...
Regards.
K40 origanal power supply
-
- Posts: 2
- Joined: Mon Feb 29, 2016 3:14 pm
- Location: USA
- Contact:
Who is online
Users browsing this forum: No registered users and 57 guests