Out1 function inverted on LOx7?

[geotek]

I'm upgrading from an AWC608 to the x7. It appears the function of OUT1 is inverted, or is it me?

[MitchL]

I'm upgrading from an AWC608 to the x7. It appears the function of OUT1 is inverted, or is it me?

I think it's inverted too - I had to change my supervisor controller's code to compensate, so yes, it appears to be inverted.

/Mitch.

[geotek]

Thanks. I use the Out1 to control a compressed air solenoid and the exhaust blower. The blower operates during cutting and turns off 1 minute after cutting. Helps keep noise down in the shop.