PC application to handle the AWC608 controller

[cimanti]

Good Morning.
We want to make a PC application to handle the AWC608 controller by
TCP and serie communication.
For example: send an image to controller and repeat it 2 times, change laser configuration (speed, power, etc.). It's possible to do it?
Where I can get documentation of network messages and commands that can handle the controller?
Thank you very much.
A greeting.

[Tech_Marco]

Sorry we can't support programming down to the network layer protocol. FYI, it is a universal controller card to support DIY folks in general. And it is also a commercial grade DSP controller widely being used in China for laser machine manufacturers. Therefore, most features have to be in 'common' to some extend. Otherwise, there would be having too much different copies of LaserCad floating around

Marco