Page 1 of 1
DSP Control Panel
Posted: Tue Jan 16, 2018 9:51 am
by BrofessorBSV
Hello,
Pretty new to world of k40 and laser engraving to the point where I went all out and got k40 and all upgrades.
Now, seems that DSP (I bought x7) is much smaller than opening of my laser. I found that LightObject use to have acrylic DSP Control Panel, but when I called them they said they have removed template. Question is, does anyone have that template saved as it appears I can't locate it anywhere.
Thank you.
Re: DSP Control Panel
Posted: Mon Jan 22, 2018 4:09 pm
by Tech_Marco
A while ago (possible in 1.5 years ago) I have made a post and asked if anyone was interested to get the mount plate because I was planning to make some and selling it for $10. Since no reply so I didn't make it any more.
Now, I will make some with metal because we have fiber laser here that can handle both steel and stainless steel. I will make a few samples and post it on our shop.
Marco
Re: DSP Control Panel
Posted: Sun Feb 04, 2018 6:53 pm
by Q*bert
Tech_Marco wrote:A while ago (possible in 1.5 years ago) I have made a post and asked if anyone was interested to get the mount plate because I was planning to make some and selling it for $10. Since no reply so I didn't make it any more.
Now, I will make some with metal because we have fiber laser here that can handle both steel and stainless steel. I will make a few samples and post it on our shop.
Marco
Hi Marco-
Could you please keep us updated when you have these available?
Re: DSP Control Panel
Posted: Mon Feb 05, 2018 9:36 am
by Tech_Marco
Sure. I'll make a couple design with different materials like stainless steel and/or acrylic
Marco
Re: DSP Control Panel
Posted: Wed Feb 21, 2018 8:38 pm
by BrofessorBSV
Awesome. I fabricated one out of Aluminum sheet, but wouldnt mind supporting your design.