DSP Control Panel

BrofessorBSV
Posts: 3
Joined: Thu Jan 04, 2018 12:18 pm

DSP Control Panel

Postby BrofessorBSV » Tue Jan 16, 2018 9:51 am

Hello,

Pretty new to world of k40 and laser engraving to the point where I went all out and got k40 and all upgrades.

Now, seems that DSP (I bought x7) is much smaller than opening of my laser. I found that LightObject use to have acrylic DSP Control Panel, but when I called them they said they have removed template. Question is, does anyone have that template saved as it appears I can't locate it anywhere.

Thank you.
Attachments
K40Conversion_B.jpg

Tech_Marco
Posts: 4328
Joined: Mon Jun 15, 2009 3:00 pm

Re: DSP Control Panel

Postby Tech_Marco » Mon Jan 22, 2018 4:09 pm

A while ago (possible in 1.5 years ago) I have made a post and asked if anyone was interested to get the mount plate because I was planning to make some and selling it for $10. Since no reply so I didn't make it any more.

Now, I will make some with metal because we have fiber laser here that can handle both steel and stainless steel. I will make a few samples and post it on our shop.


Marco

Q*bert
Posts: 22
Joined: Thu Feb 25, 2016 8:57 am

Re: DSP Control Panel

Postby Q*bert » Sun Feb 04, 2018 6:53 pm

Tech_Marco wrote:A while ago (possible in 1.5 years ago) I have made a post and asked if anyone was interested to get the mount plate because I was planning to make some and selling it for $10. Since no reply so I didn't make it any more.

Now, I will make some with metal because we have fiber laser here that can handle both steel and stainless steel. I will make a few samples and post it on our shop.


Marco


Hi Marco-

Could you please keep us updated when you have these available?

Tech_Marco
Posts: 4328
Joined: Mon Jun 15, 2009 3:00 pm

Re: DSP Control Panel

Postby Tech_Marco » Mon Feb 05, 2018 9:36 am

Sure. I'll make a couple design with different materials like stainless steel and/or acrylic

Marco

BrofessorBSV
Posts: 3
Joined: Thu Jan 04, 2018 12:18 pm

Re: DSP Control Panel

Postby BrofessorBSV » Wed Feb 21, 2018 8:38 pm

Awesome. I fabricated one out of Aluminum sheet, but wouldnt mind supporting your design.


Return to “Laser products”

Who is online

Users browsing this forum: No registered users and 1 guest