Howdy. New forum member here. I just bought the T9 card and I'm trying to hook it up tonight but not having much luck. When I power the machine on, the laser head moves in a straight line on the X axis and runs straight into the limit switch but doesn't register it, it just rams into the side and the motors keep running until I stop it.Tech_Marco wrote:Read the "FAQ" first please
You need to understand the basic of the controller and how to configure the software parameters before asking for help. It is hard for me to do step by step each time a customer purchase a card. Most your questions were covered in the FAQ I posted
Thx
I'm running an Artsign JSM-3060N cutter. I'm assuming there is an issue with how I wire the limit switch. On the previous board the X- and Y- were wired into one set of connectors but the grounds seems to be combined and wired into the other set of connectors that had the Z+ and Z- limits. So right now I don't have a ground connection where the X and Y limit switches are wired to the T9 board... can I just jumper them with a wire?