AWC608 and LO-X7 connection diagram

Tech_Marco
Posts: 4313
Joined: Mon Jun 15, 2009 3:00 pm

AWC608 and LO-X7 connection diagram

Postby Tech_Marco » Thu Feb 05, 2015 4:28 pm

Manual: AWC608
download/manual/AWC608_Manual.pdf

LO-X7
download/manual/AWC708CLITE_Manual.pdf

Interface:
download/manual/AWC608_Interface.pdf

Connection diagram:
download/manual/DSPConnection.pdf

Note:
1) The configuration setting is default to the K40 machine. For other type of laser machine, the configuration need to change accordingly.
For example, the motor driver and it's current need to be changed based on the stepping motor specification. The microstepping may need to change to from 1/16(3200) to 4000 or 5000
2) For bigger machine with higher current motor, you may want to use DC36V or 48V to power the motor driver instead of DC24V currently used on the diagram. It has better efficiency with higher DC voltage to the motor.
3) For bigger wattage laser tube, you should NOT use an Emergency switch as the circuit breaker because it can't handle over 3A current. You may want to install a solenoid (mechanic relay) or a SSR (Solid State relay) to serves as a current breaker
4) Turn off any anti-virus program when doing LaserCad installation or OS upgrade. You must need to remove all files saved in the DSP memory before doing OS upgrade.

Return to “DSP controller”

Who is online

Users browsing this forum: No registered users and 1 guest