2012 DSP AWC608 will it work with Lightburn

[Blasttiod]

Hi all/Marco,
I built my laser back around 2012(using parts purchased form Lightobject) and now wish to move to the Lightburn software but can not get it to talk to Lightburn.
Any suggestions or is the controller to old?

My controller:
2012 DSP AWC608

Regards
Kevin Campkin

[Tech_Marco]

This may help
https://forum.lightburnsoftware.com/t/n ... elp/6923/2

[daveman]

My older AWC608 (older than yours) works fine with LightBurn. Matter of fact I only use LightBurn with it because LaserCAD makes it double cut internal cuts after upgrading to latest version and can't for the life of me figure out how to make it stop.