What is the key sequence to get into Pre-ignition settings on the LO-E5?
Lasercad does not access this.
I was told by Sam last night that this was possible.
How do I turn on "Pre-ignition" for RF?
-
- Posts: 17
- Joined: Wed Apr 09, 2014 10:26 am
- Location: Danvers, MA
- Contact:
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: How do I turn on "Pre-ignition" for RF?
See image
For RF, I was told that the frequency should be set to '5000Hz'
Marco
You can't change the % or time because it should be handled by your RF tube/ circuitry internallyFor RF, I was told that the frequency should be set to '5000Hz'
Marco
Who is online
Users browsing this forum: No registered users and 1 guest