RayCAM not able to communicate with LO E5
Posted: Wed Jan 04, 2017 11:31 am
Hello,
I purchased an E5 DSP in early December 2016 and have not been able to connect to it with RayCAM when hitting "Select Mode" and "Find Com", LaserCAD connected first try. The E5 has version 160428 installed so I thought it might be that I needed to update the firmware, using the firmware upgrade found here viewtopic.php?f=55&t=3435 I get an error message when attempting to update. USB is formatted to fat32 and the E5 can see the file and attempts to update then gives me an error message.
Thank you,
Troy
I purchased an E5 DSP in early December 2016 and have not been able to connect to it with RayCAM when hitting "Select Mode" and "Find Com", LaserCAD connected first try. The E5 has version 160428 installed so I thought it might be that I needed to update the firmware, using the firmware upgrade found here viewtopic.php?f=55&t=3435 I get an error message when attempting to update. USB is formatted to fat32 and the E5 can see the file and attempts to update then gives me an error message.
Thank you,
Troy