4th Axis help

Post Reply
kmyerslp
Posts: 9
Joined: Sat May 27, 2017 5:47 pm
Contact:

4th Axis help

Post by kmyerslp »

I have mechanical and firmware settings figured out and set. I can jog the U axis on the machine just fine. No matter what setting I choose or change I cannot get the U axis to move during a job. The attachment is what LOworks only shows. LOworks version 8.01.24

Edit: Further research has shown that a lot of people just unhook the respective axis to wire up the rotary in it's place which is not a legitimate answer for me considering I bought the controller knowing its a 4 axis controller. Any 3 axis controller could use this "workaround" to be ran this way and that's the reason I went with the R5. Is there a way to make this work?
Attachments
ugh.jpg
ugh.jpg (26.01 KiB) Viewed 2931 times
Post Reply

Return to “DSP R5”

Who is online

Users browsing this forum: No registered users and 1 guest