Page 1 of 1
Rotary will not reverse
Posted: Tue May 07, 2019 12:25 pm
by rbryndza
I just got around to adding the rotary to my laser. The U axis will not reverse. I can swap it with the Z and it will reverse. Is there something I am missing or is this controller going in the trash...
I have reloaded the firmware and no change.
Thanks for any help
Re: Rotary will not reverse
Posted: Tue May 07, 2019 1:24 pm
by mrsunnylam
what controller do you have?
Re: Rotary will not reverse
Posted: Tue May 07, 2019 5:38 pm
by rbryndza
T9
Re: Rotary will not reverse
Posted: Thu May 09, 2019 8:39 am
by mrsunnylam
I would check the wiring to the stepper driver again. In the menu on the DSP T9 controller under U/Z axis and check the box that says rotary. stepper driver should be around 12800 steps. can you take a picture of your wiring? that would help the group.
Re: Rotary will not reverse
Posted: Tue May 14, 2019 6:49 am
by rbryndza
Ended up being a bad t9 controller
Re: Rotary will not reverse
Posted: Wed May 15, 2019 7:56 am
by Tech_Marco
It could be the front panel keypad. Should we send you na new one for trying?
Marco