I just got around to adding the rotary to my laser. The U axis will not reverse. I can swap it with the Z and it will reverse. Is there something I am missing or is this controller going in the trash...
I have reloaded the firmware and no change.
Thanks for any help
Rotary will not reverse
-
- Posts: 3
- Joined: Fri Feb 16, 2018 11:34 am
- Contact:
-
- Posts: 67
- Joined: Tue Oct 30, 2018 11:18 am
- Contact:
Re: Rotary will not reverse
what controller do you have?
-
- Posts: 3
- Joined: Fri Feb 16, 2018 11:34 am
- Contact:
-
- Posts: 67
- Joined: Tue Oct 30, 2018 11:18 am
- Contact:
Re: Rotary will not reverse
I would check the wiring to the stepper driver again. In the menu on the DSP T9 controller under U/Z axis and check the box that says rotary. stepper driver should be around 12800 steps. can you take a picture of your wiring? that would help the group.
-
- Posts: 3
- Joined: Fri Feb 16, 2018 11:34 am
- Contact:
Re: Rotary will not reverse
Ended up being a bad t9 controller
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: Rotary will not reverse
It could be the front panel keypad. Should we send you na new one for trying?
Marco
Marco
Who is online
Users browsing this forum: No registered users and 5 guests