Hi,
I'm doing a job using the array replication from lasersoft software but I notice that although it is indeed doing the array it is doing one by one, meaning it engraves one piece, then cuts it and moves to the next one.
How can I make it engrave all the parts in one turn and next cut them altogether ?
I have thousand of parts to engrave and cut and this way it'll take much longer.
Thank you
Array replication settings
-
- Posts: 36
- Joined: Thu Jan 18, 2018 10:57 am
- Contact:
Array replication settings
Last edited by Hydrops on Fri May 18, 2018 9:34 am, edited 1 time in total.
-
- Posts: 36
- Joined: Thu Jan 18, 2018 10:57 am
- Contact:
Re: Array replication settings
So I found out a way to do it
It might help so the way I did it was to do the array copy before transferring to bitmap, is this the correct way to do it ?
It might help so the way I did it was to do the array copy before transferring to bitmap, is this the correct way to do it ?
Who is online
Users browsing this forum: No registered users and 43 guests