XY Limits

robertlroberts
Posts: 6
Joined: Wed Dec 13, 2017 6:10 pm

XY Limits

Postby robertlroberts » Sat Dec 23, 2017 9:20 am

I have set up my 1200X1800 XY table and am attempting to adjust the limits. when I set the limits to 1200 and 1800 the DSP registers 900 X 900. I have 3 phase steppers and 3MD560 controllers. The controllers are set to 6400 steps per rev. How can get the DSP to accept my desired limits.

Tech_Marco
Posts: 4347
Joined: Mon Jun 15, 2009 3:00 pm

Re: XY Limits

Postby Tech_Marco » Sat Dec 23, 2017 9:49 am

You need to get proper “um” value first before you can get proper limit range. See the “FAQ” to see how to

Also, I suggest not going over 5000 on micro stepping setup.

***Merry Christmas ***

Marco


Return to “DSP T9”

Who is online

Users browsing this forum: No registered users and 1 guest