Lightobject.com Support Forum

Will carry some 5V I/O board soon
Relay output

HELLO
this is Jaime and I am new on this. I replace the boards from my machine and add a dsp t9 controller. at one moment tried to do a sample but in the controller appeared a display with this:
X axis cross border
press the escape key.
i dont know if wrong connections or some settings are out of parameters.
in other hand in tried to get the manual at support forum but i couldn't find it.
can somebody let me know how to get the manual for the dsp t 9 ?

First, you need to check these:
1) Workspace: make sure the size you set up here is within the limit of your machine
2) 'UM' calibration
3) Machine zero and Page zero matched your HOME location

Marco