X7 lite help
Posted: Sun Feb 24, 2019 6:57 pm
I bought a used k40 with the LO-X7 life upgrade and it has the AWC708C controller. I am trying for figure out what it is capable of and have some questions.
1. What is the latest firmware I should be using and where do I get it?
2. Can it do greyscale?
3. I can’t connect to the laser with RayCam but can with LaserCAD so does that mean it is an older version?
4. If it is the older version can it be upgraded to the with firmware to use the raycam?
5. What are the new features of the new version x7?
Any help would be great. I bought this and it was just the laser no software or manuals for anything so learning on the fly.
1. What is the latest firmware I should be using and where do I get it?
2. Can it do greyscale?
3. I can’t connect to the laser with RayCam but can with LaserCAD so does that mean it is an older version?
4. If it is the older version can it be upgraded to the with firmware to use the raycam?
5. What are the new features of the new version x7?
Any help would be great. I bought this and it was just the laser no software or manuals for anything so learning on the fly.