Adjusting Cutting/Bed Area/Size in Raycam

Post Reply
BrofessorBSV
Posts: 3
Joined: Thu Jan 04, 2018 12:18 pm
Contact:

Adjusting Cutting/Bed Area/Size in Raycam

Post by BrofessorBSV »

Hello,

Finally after months of delays and such my k40 has been fully upgraded thanks to LO parts. I also have power z table now as well. My question is as I can't seem to figure out is how to adjust cutting/engraving area within Raycam Software to reflect new size of the bed? (LaserCad for whatever reason I cannot seem to connect to K40, but Raycam does). Also how would I adjust new 0-0 (i guess that's whats it called or new 0s position).

Thank you
Post Reply

Return to “DSP X7”

Who is online

Users browsing this forum: No registered users and 17 guests