Adjusting Cutting/Bed Area/Size in Raycam

Posts: 3
Joined: Thu Jan 04, 2018 12:18 pm

Adjusting Cutting/Bed Area/Size in Raycam

Postby BrofessorBSV » Mon Jul 23, 2018 7:37 am


Finally after months of delays and such my k40 has been fully upgraded thanks to LO parts. I also have power z table now as well. My question is as I can't seem to figure out is how to adjust cutting/engraving area within Raycam Software to reflect new size of the bed? (LaserCad for whatever reason I cannot seem to connect to K40, but Raycam does). Also how would I adjust new 0-0 (i guess that's whats it called or new 0s position).

Thank you

Return to “DSP X7”

Who is online

Users browsing this forum: No registered users and 2 guests