1 post • Page 1 of 1
Not sure if this is the right place for this but here it goes. I engrave maps with lots of text. All work is done in illustrator, text is converted to outlines and then imported into raycam. This has worked flawlessly for the last 20-30 times, but today for some reason all the letter "H"'s are blown way off the map! This has never happened before so I don't really know where to begin. I can manually grab those letters in raycam and put them back in place, though precise positioning will be difficult, but with many maps to come I'd rather find out how to fix it. Suggestions?
Who is online
Users browsing this forum: No registered users and 11 guests