First time firing my LO-x7 - got some issues
Posted: Sat Dec 30, 2017 7:30 pm
Hello guys,
Fired up the X7 - X,Y Z axis are working fine. Two issues: (I ran this without the Laser PSU)
1. I cannot set the Hardware limit switches in the manufacturer parameter page - I press the "read" then tick the HW limit and "save" with password,
press "Reset" and when I do "read" again - the tick is gone... My limit switches don't work - checked continuity however I guess the machine does not see them for some reason. Strangely enough - the "up" and"Left" are work in Homing, but they don't work when I push them to see if they stop.
2. Tried to run a small program of a square - file loaded OK but when pressing START - machine goes to PAUSE with a 0% or 25% ... does this have to do anything with the Laser PSU not working ? Is there a way to run the file with no laser power?
Many thanks
Isaac
Fired up the X7 - X,Y Z axis are working fine. Two issues: (I ran this without the Laser PSU)
1. I cannot set the Hardware limit switches in the manufacturer parameter page - I press the "read" then tick the HW limit and "save" with password,
press "Reset" and when I do "read" again - the tick is gone... My limit switches don't work - checked continuity however I guess the machine does not see them for some reason. Strangely enough - the "up" and"Left" are work in Homing, but they don't work when I push them to see if they stop.
2. Tried to run a small program of a square - file loaded OK but when pressing START - machine goes to PAUSE with a 0% or 25% ... does this have to do anything with the Laser PSU not working ? Is there a way to run the file with no laser power?
Many thanks
Isaac