Issue with the X7 DSP CONTROLLER
Posted: Fri Dec 29, 2017 11:14 pm
I went into the laser cad software and entered the size of my laser 900 x 1200, but when I try and cut something that size I get an error that says object to large. Is there somewhere in the controller that I can set table size.
When I am doing an engraving and cut I have the file setup to engrave then cut. It does this action in a random order. It may start engraving then cut some then start engraving. Any solutions?
Thanks in advance for the help. other than these issues the controller works really great.
When I am doing an engraving and cut I have the file setup to engrave then cut. It does this action in a random order. It may start engraving then cut some then start engraving. Any solutions?
Thanks in advance for the help. other than these issues the controller works really great.