Very embarrassing question
Posted: Sun Apr 09, 2017 5:45 pm
I have had to replace my Corel software on the computer that I use to control my laser. I have a K40 with DSP and am needing to know how to link my Corel Draw to Laser Cad so the link shows in the toolbar of Corel. I can not remember how this is done. I think it has probably been over 5 years since I last had to do this. Any help is appreciated. For some reason I believe that I had to do that from the Laser Cad software at the time of installation. I hope not, as I no longer have the install file for the software. Any help is appreciated.
Milt
Milt