I have been using Awc-608 and windows 7 laptop with Lasercad 7.57 installed with no issues.
I have purchased different windows 10 laptop and installed Lasercad 7.57, when i open files with Lasercad that were saved from previous setup i cannot see the cut lines when "Zoom To Page" but they appear when i select "Zoom To All Objects".
If i open an old file on new computer and re-save, reopen it, the issue remains, but....
If i open Lasercad on the new computer and create a file, save it and then open it again, i do not have this issue.
Can anyone advise?
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests