Change zero coords? Homing offsets?

Post Reply
moo10032
Posts: 1
Joined: Wed Feb 01, 2017 5:10 pm
Contact:

Change zero coords? Homing offsets?

Post by moo10032 »

How do you change the homing offsets? I want me machine to home itself, and then move to the corner of the bed which is at 0, 30. I have a jig setup there so I don't want to work in anything bu "soft origin" work mode. How do you go around this? Right now I'm having to just remember to move all my cuts down below 30mm in raycam.

Thanks!
Dean315
Posts: 11
Joined: Thu Jun 11, 2015 2:19 pm
Contact:

Re: Change zero coords? Homing offsets?

Post by Dean315 »

I'm having exactly the same issue. Did get it solved? I'm using LaserCad but I'm sure that doesn't matter.

Dean
ChrisBorg
Posts: 14
Joined: Fri Nov 25, 2016 6:57 pm
Contact:

Re: Change zero coords? Homing offsets?

Post by ChrisBorg »

Move the head to the exact position you want using the software. Then push the origin button on the LCD screen which resets the home position.
Techgraphix
Posts: 492
Joined: Fri Jan 20, 2012 1:39 pm
Location: Appelscha, the Netherlands
Contact:

Re: Change zero coords? Homing offsets?

Post by Techgraphix »

Or mechanicaly position the home-sensor to the appropriate coordinates: move it 30mm to the left/right/forward/back.
Or mechanically extend the sensor-trigger by 30mm.
Or set your origin right (like ChrisBorg said)

BTW i always use a origin somewhere where i can position my material easily..

Kees
Post Reply

Return to “DSP X7”

Who is online

Users browsing this forum: No registered users and 17 guests