Hi,
When I import a DXF file into RayCam 1.2 it appears 10% of it's correct size, so an objet that is say 150 mm on the X axis is only 15mm wide.
Brand new insatll of RayCam to go with X7 DSP controller just installed to replace 6515 setup.
Thanks,
Chris
RayCam 1.2 DXF import problem
-
- Posts: 3
- Joined: Wed Nov 02, 2016 4:48 am
- Contact:
-
- Posts: 492
- Joined: Fri Jan 20, 2012 1:39 pm
- Location: Appelscha, the Netherlands
- Contact:
Re: RayCam 1.2 DXF import problem
I don't know RayCam (yet) but it sounds to me like the DXF-file is written in centimeters and imported in RayCam as (the default) millimeters.
Check the program that creates your DXF if you can find something about the format (Inch/MM/CM..)
Kees
Check the program that creates your DXF if you can find something about the format (Inch/MM/CM..)
Kees
-
- Posts: 3
- Joined: Wed Nov 02, 2016 4:48 am
- Contact:
Re: RayCam 1.2 DXF import problem
Ok I will check tomorrow, the DXF file is exported from Corel Draw X6...
Chris
Chris
-
- Posts: 3
- Joined: Wed Nov 02, 2016 4:48 am
- Contact:
Re: RayCam 1.2 DXF import problem
It seems that it depends from where the DXF file was exported:
Adobe Illustrator - correct scaling
Corel Draw - 10% of full size
p.s. the reason I am using RayCam in the first place is that LaserCad wouldn't talk via USB to my new (November 2016) X7 controller, RayCam worked straight off.
Adobe Illustrator - correct scaling
Corel Draw - 10% of full size
p.s. the reason I am using RayCam in the first place is that LaserCad wouldn't talk via USB to my new (November 2016) X7 controller, RayCam worked straight off.
Who is online
Users browsing this forum: No registered users and 20 guests