Return home after job

Post Reply
seeigecannon
Posts: 44
Joined: Thu Oct 22, 2015 9:35 pm
Contact:

Return home after job

Post by seeigecannon »

Is there any setting that I can change that will make the laser return to its home position after it has finished doing its job? Right now it just returns to whatever corner I started the job at, but I would prefer it move out of the way completely on its own. Thoughts?
jhuangupp
Posts: 9
Joined: Thu Mar 31, 2016 10:04 am
Contact:

Re: Return home after job

Post by jhuangupp »

Please do this in the LCD control panel:

Menu->common parameters setting-> work mode->go back position ->zero coordinate.
seeigecannon
Posts: 44
Joined: Thu Oct 22, 2015 9:35 pm
Contact:

Re: Return home after job

Post by seeigecannon »

jhuangupp wrote:Please do this in the LCD control panel:

Menu->common parameters setting-> work mode->go back position ->zero coordinate.
Is that for the AWC-608? I don't remember seeing a settings like that.
jhuangupp
Posts: 9
Joined: Thu Mar 31, 2016 10:04 am
Contact:

Re: Return home after job

Post by jhuangupp »

Th feature is currently available to X7 DSP controller.
Post Reply

Return to “DSP X7”

Who is online

Users browsing this forum: No registered users and 19 guests