I looked through the options tab in LaserCAD and am 90-95% sure I didn't change a thing. I then closed LaserCAD and later reopened through the Corel Macro and noticed that my speed and power % were changed. Upon further testing, my laser now engraves from the bottom instead of the top.
Like I said, there is a small possibility that I changed something but probably did not. Even if I did, there was no way I changed multiple things. So has the system been known to revert back to a previous setting? And if the settings are different, what else might have changed?
Setting changed, or system reverted to old settings
-
- Posts: 11
- Joined: Tue Jun 30, 2015 6:18 pm
- Contact:
-
- Posts: 71
- Joined: Tue Jun 02, 2015 11:55 pm
- Contact:
Re: Setting changed, or system reverted to old settings
This happened to me twice. I am not sure where it came from but now i always backup my values so i can restore them.
tm
tm
Who is online
Users browsing this forum: No registered users and 35 guests