K40 origanal power supply

Post Reply
[email protected]
Posts: 2
Joined: Mon Feb 29, 2016 3:14 pm
Location: USA
Contact:

K40 origanal power supply

Post by [email protected] »

I have a 40w cheap laser. I installed the AWC608 upgrade using the original laser power supply. The laser will only fire at about 25% of full power. I found what I think is the pinout of the supply (see image). I can wire up a button and a pot and get it fire at full power. Also after a few test runs the display text has gotten very dim. Maybe an controller issue? Please advise...
Regards.
Attachments
SP1.png
SP1.png (73.28 KiB) Viewed 1220 times
20160306_151637.jpg
Post Reply

Return to “DSP X7”

Who is online

Users browsing this forum: No registered users and 21 guests