semi 3D engraving with 608
Posted: Fri Jan 15, 2016 11:08 am
Hi all
I always see discussion about semi 3D engraving ( grey scale)
OK I have lots of success with my old 608 to do this.
her is how I do it :
1. load pic in corel photopaint and resample to the size I need and 600 DPI and convert to grey scale, save it as BMP
2. load the pic in lasercad dithered with 0.015 and set the scan to 0.04 and the speed to 100 to 150
and that's it.
sometimes depending on the material I give it a second run with the same settings
maybe this helps a bit
greetings waltfl
I always see discussion about semi 3D engraving ( grey scale)
OK I have lots of success with my old 608 to do this.
her is how I do it :
1. load pic in corel photopaint and resample to the size I need and 600 DPI and convert to grey scale, save it as BMP
2. load the pic in lasercad dithered with 0.015 and set the scan to 0.04 and the speed to 100 to 150
and that's it.
sometimes depending on the material I give it a second run with the same settings
maybe this helps a bit
greetings waltfl