Lately I have been getting the following message everytime I power up the DSP: "Continue to work after Powerout?"
I hit escape and the lcd returns to normal home screen. I shut down the same way I always have..but maybe I changed a setting on the controller - any suggestions?
"Continue to work after Powerout?" message SOLVED
-
- Posts: 91
- Joined: Thu May 21, 2015 9:44 am
- Contact:
"Continue to work after Powerout?" message SOLVED
Last edited by funhawke on Sun Sep 13, 2015 9:23 am, edited 1 time in total.
-
- Posts: 492
- Joined: Fri Jan 20, 2012 1:39 pm
- Location: Appelscha, the Netherlands
- Contact:
Re: "Continue to work after Powerout?" message
It means there is an unfinished job in your memory.. When you delete that job, the message is gone too..
Kees
Kees
-
- Posts: 26
- Joined: Wed Apr 08, 2015 7:04 pm
- Contact:
Re: "Continue to work after Powerout?" message
I have deleted all the jobs and formatted the memory thing (on the download screen on the pc side) more than once and still always get this message, I have for months.
Techgraphix wrote:It means there is an unfinished job in your memory.. When you delete that job, the message is gone too..
Kees
-
- Posts: 492
- Joined: Fri Jan 20, 2012 1:39 pm
- Location: Appelscha, the Netherlands
- Contact:
Re: "Continue to work after Powerout?" message SOLVED
And what if you say yes to continue the job? (without material and way off-focus)
Kees
Kees
Who is online
Users browsing this forum: No registered users and 24 guests