Code to write parameters.

dekaltrim · Post by **dekaltrim** » Mon Jun 07, 2010 3:38 am

Hi.

Then i want to write parameters to the PH-board from Rlasercut it ask for password. I have tried with the six digit number included in install package but i will not work. Any suggestions?

Best regards, Klas Pettersson - Sweden.

Tech_Marco · Post by **Tech_Marco** » Mon Jun 07, 2010 10:33 am

811104 (Master key code to release demo time)
9xfc88 (Write)

dekaltrim · Post by **dekaltrim** » Mon Jun 07, 2010 10:55 am

It gives password error. I change something on X-axis and push write. Then i type 9xfc88. And i get password error back as answer. My card is PH/Board v1.2 and i download rlasercut from your pages yesterday.

And the code button under settings is grey and not possible to use.

maralb · Post by **maralb** » Mon Jun 07, 2010 12:21 pm

Tech_Marco · Post by **Tech_Marco** » Mon Jun 07, 2010 12:37 pm

How about "634590"

dekaltrim · Post by **dekaltrim** » Mon Jun 07, 2010 4:44 pm

It was wrong code. It should be gxfc88 instead of 9xfc88. so it solved now with a little bit help.

Thanks.

Tech_Marco · Post by **Tech_Marco** » Mon Jun 07, 2010 10:20 pm

Ding~~~ how could I miss that! Yes, it's 'g' not '9'

Thank you

Lightobject.com Support Forum

Code to write parameters.

Code to write parameters.

Re: Code to write parameters.

Re: Code to write parameters.

Re: Code to write parameters.

Re: Code to write parameters.

Re: Code to write parameters.

Re: Code to write parameters.

Who is online