Were is the datsheet for the 4 axis board?

CNCMANIAC · Post by **CNCMANIAC** » Mon Oct 05, 2009 9:36 am

Hi,
I just open the box with the 4 axis controller and It was delivery without datasheet.
So I figure how to connect the 24V supply but I see a 5V plug...
I also read on the forum that there is no way onboard to adjust the output current
So how can we see what current is setting in?

Is there any data concerning this board?

Thanks,
J-P

Tech_Marco · Post by **Tech_Marco** » Wed Oct 07, 2009 10:43 am

For now ,please review the 3-axis controller as it's almost identical, except that the 4-axis do need an 5V to poer it (dual power in this case). I'm working on the manual for the 4-axis. Thank you for your patience.

Tech_Marco · Post by **Tech_Marco** » Wed Oct 07, 2009 10:50 am

Current can be set by changing those 4 resistor on the board. For example, for 1.5A, use 0.5ohm (5watt)

CNCMANIAC · Post by **CNCMANIAC** » Mon Oct 12, 2009 1:51 pm

Were is the 3 axis datasheet?
J-P

Tech_Marco · Post by **Tech_Marco** » Tue Oct 13, 2009 4:26 pm

forum/viewforum.php?f=16

Lightobject.com Support Forum

Were is the datsheet for the 4 axis board?

Were is the datsheet for the 4 axis board?

Re: Were is the datsheet for the 4 axis board?

Re: Were is the datsheet for the 4 axis board?

Re: Were is the datsheet for the 4 axis board?

Re: Were is the datsheet for the 4 axis board?

Who is online