The door switch on the X7 (port 11 IN) - is it NO or NC ? Have seen some conflicting diagrams.
To make it clear - when door is closed - should the controller get closed circuit or open circuit to allow the machine to work ?
2 posts • Page 1 of 1
- Posts: 461
- Joined: Fri Jan 20, 2012 1:39 pm
- Location: Appelscha, the Netherlands
Both are posible: you can set that level in the controller.. I use a proxy to detect the position of the lid/cap. This will output a 0 (zero) when the lid is closed.
Who is online
Users browsing this forum: No registered users and 3 guests