X7 DSP Origin Button - How does it work?

Post Reply
cryoteck
Posts: 7
Joined: Thu Apr 06, 2017 4:55 pm
Contact:

X7 DSP Origin Button - How does it work?

Post by cryoteck »

Hi, just finished upgrading my 60W laser with the X7 DSP :)

Now I can Jog the Steppers fine (X-Y) and even start the default program by pressing start.

My Question is about the ORIGIN button on the keypad...

Example if I Jog the steppers around the center, and then press Start the head goes back to the Top-Left (where the limit switches are) and starts the program.

Now if I Jog again to the center press the ORIGIN button and press Start again, the head still goes back to Top-Left and start the program from there?

My guess was that by pressing the ORIGIN button it would set the starting point of the program? Am I wrong or am I missing something?

Thank you for any help,

Yvan
tansh
Posts: 24
Joined: Thu Dec 31, 2015 12:06 am
Contact:

Re: X7 DSP Origin Button - How does it work?

Post by tansh »

Press "Menu" button on the keypad, select "Common Parameters Settings" then select "Work Mode". Make sure that "Go origin After Reset" = Enable, and "Origin Mode" = Key Origin.
Post Reply

Return to “DSP X7”

Who is online

Users browsing this forum: No registered users and 12 guests