coreldraw & ramcam to import

Post Reply
tehamatees
Posts: 1
Joined: Fri Dec 30, 2016 5:12 pm
Location: RED BLUFF, CA
Contact:

coreldraw & ramcam to import

Post by tehamatees »

I am a Coreldraw user (x6) and I just downloaded RAYCAM. I am trying to import CORELDRAW files into Raycam and Raycam wont recognize them. What do I need to do to make this work?. I've used the computers and machines at L.O. Hq and there is a shortcut tab (top tool menus line) in their computer that jumps from Coreldraw to Raycam. What do I need to do to succeed?
Tech_Marco
Posts: 4646
Joined: Mon Jun 15, 2009 3:00 pm
Contact:

Re: coreldraw & ramcam to import

Post by Tech_Marco »

Run the RayCam installation program and select CorelDraw add on module. Select the version and point to the correct path and that should take care it for you

Marco
Winstonc
Posts: 26
Joined: Sat Feb 18, 2017 10:54 am
Contact:

Re: coreldraw & ramcam to import

Post by Winstonc »

I am trying to install the RayCAM plugin for CorelDraw X8 and after choosing the right version and directory it keeps comming back with directory not found. I have tried every combination I can think of with the same results.

Any suggestions?

Thanks

David
Tech_Marco
Posts: 4646
Joined: Mon Jun 15, 2009 3:00 pm
Contact:

Re: coreldraw & ramcam to import

Post by Tech_Marco »

So far both RayCam or LaserCad supports CorelDraw up to version 7.0 only
Will discuss with the programmer soon about the issue

Marco
Winstonc
Posts: 26
Joined: Sat Feb 18, 2017 10:54 am
Contact:

Re: coreldraw & ramcam to import

Post by Winstonc »

Ok, thanks Marco
Winstonc
Posts: 26
Joined: Sat Feb 18, 2017 10:54 am
Contact:

Re: coreldraw & ramcam to import

Post by Winstonc »

Does the plugin only work with the full version of the Coreldraw X7 or will it work with the Home and Student version? Just wanted to check before I buy.

Thanks

David
Winstonc
Posts: 26
Joined: Sat Feb 18, 2017 10:54 am
Contact:

Re: coreldraw & ramcam to import

Post by Winstonc »

I think I have answered my own question and the answer is it requires the full version to get macro support.

David
Post Reply

Return to “Tips and new on the DSP & Software”

Who is online

Users browsing this forum: No registered users and 4 guests