Page 1 of 1
coreldraw & ramcam to import
Posted: Sat Jan 14, 2017 7:39 pm
by tehamatees
I am a Coreldraw user (x6) and I just downloaded RAYCAM. I am trying to import CORELDRAW files into Raycam and Raycam wont recognize them. What do I need to do to make this work?. I've used the computers and machines at L.O. Hq and there is a shortcut tab (top tool menus line) in their computer that jumps from Coreldraw to Raycam. What do I need to do to succeed?
Re: coreldraw & ramcam to import
Posted: Sun Jan 15, 2017 10:30 am
by Tech_Marco
Run the RayCam installation program and select CorelDraw add on module. Select the version and point to the correct path and that should take care it for you
Marco
Re: coreldraw & ramcam to import
Posted: Thu Feb 23, 2017 5:22 pm
by Winstonc
I am trying to install the RayCAM plugin for CorelDraw X8 and after choosing the right version and directory it keeps comming back with directory not found. I have tried every combination I can think of with the same results.
Any suggestions?
Thanks
David
Re: coreldraw & ramcam to import
Posted: Fri Feb 24, 2017 8:05 am
by Tech_Marco
So far both RayCam or LaserCad supports CorelDraw up to version 7.0 only
Will discuss with the programmer soon about the issue
Marco
Re: coreldraw & ramcam to import
Posted: Fri Feb 24, 2017 8:08 am
by Winstonc
Ok, thanks Marco
Re: coreldraw & ramcam to import
Posted: Fri Feb 24, 2017 10:45 pm
by Winstonc
Does the plugin only work with the full version of the Coreldraw X7 or will it work with the Home and Student version? Just wanted to check before I buy.
Thanks
David
Re: coreldraw & ramcam to import
Posted: Sat Feb 25, 2017 9:21 am
by Winstonc
I think I have answered my own question and the answer is it requires the full version to get macro support.
David