Page 1 of 1
Move files from laser to computer?
Posted: Fri Oct 28, 2016 11:47 am
by BazzaM
Is there is any way of getting the files off the laser cutter back on to a computer?
Suffered a hard drive failure and got some files on a USB but how can move files from the K40 to the computer please?
Thank you
Bazza
Re: Move files from laser to computer?
Posted: Fri Oct 28, 2016 1:02 pm
by bsm2003
Insert a disk in the controller and hit file->enter->select file->enter->copy to UDisk-> enter. You'll have to do it for each file.
Re: Move files from laser to computer?
Posted: Fri Oct 28, 2016 1:54 pm
by BazzaM
bsm2003 wrote:Insert a disk in the controller and hit file->enter->select file->enter->copy to UDisk-> enter. You'll have to do it for each file.
Yes but laser cad or turbo cad won't recognize it?
Re: Move files from laser to computer?
Posted: Fri Oct 28, 2016 2:13 pm
by bsm2003
It doesn't recognize Ud5 files even on the computer to open or edit. You should always save them in the editable format before saving them to the upload format. If you didn't and your hd died not much you can do but start over.