Move files from laser to computer?

BazzaM
Posts: 5
Joined: Thu Oct 29, 2015 1:23 pm

Move files from laser to computer?

Postby BazzaM » Fri Oct 28, 2016 11:47 am

Is there is any way of getting the files off the laser cutter back on to a computer?
Suffered a hard drive failure and got some files on a USB but how can move files from the K40 to the computer please?
Thank you
Bazza

bsm2003
Posts: 31
Joined: Sat Sep 10, 2016 1:17 pm

Re: Move files from laser to computer?

Postby bsm2003 » Fri Oct 28, 2016 1:02 pm

Insert a disk in the controller and hit file->enter->select file->enter->copy to UDisk-> enter. You'll have to do it for each file.

BazzaM
Posts: 5
Joined: Thu Oct 29, 2015 1:23 pm

Re: Move files from laser to computer?

Postby BazzaM » Fri Oct 28, 2016 1:54 pm

bsm2003 wrote:Insert a disk in the controller and hit file->enter->select file->enter->copy to UDisk-> enter. You'll have to do it for each file.


Yes but laser cad or turbo cad won't recognize it?

bsm2003
Posts: 31
Joined: Sat Sep 10, 2016 1:17 pm

Re: Move files from laser to computer?

Postby bsm2003 » Fri Oct 28, 2016 2:13 pm

It doesn't recognize Ud5 files even on the computer to open or edit. You should always save them in the editable format before saving them to the upload format. If you didn't and your hd died not much you can do but start over.


Return to “Tips and new on the DSP & Software”

Who is online

Users browsing this forum: No registered users and 1 guest