Laser will not Fire

Post Reply
lvmymp5
Posts: 4
Joined: Sun Jan 13, 2019 10:18 pm
Contact:

Laser will not Fire

Post by lvmymp5 »

I have the LO-x7 connected to the AWC708C both cables are CN1 and CN2 are connected. I verfied that i have 5V coming out of K- and when i press the test fire button on the LO-X7 it goes low and have it tied to TTL on the awc708c. I have G and K+ tied together to GND on the awc708c. (verfied with a dvm that they are tied together). I have pwm connected the awc708c tied to IN on the PSU. I have P and G on the PSU tied together. Alos when i push the "test Fire" on the PSU the laser fires. Trying to get some idea where to look next.

Thanks
Tech_Marco
Posts: 4646
Joined: Mon Jun 15, 2009 3:00 pm
Contact:

Re: Laser will not Fire

Post by Tech_Marco »

It is so confused here, you have two controllers ?

Marco
Techgraphix
Posts: 492
Joined: Fri Jan 20, 2012 1:39 pm
Location: Appelscha, the Netherlands
Contact:

Re: Laser will not Fire

Post by Techgraphix »

waterprotect?

Kees
lvmymp5
Posts: 4
Joined: Sun Jan 13, 2019 10:18 pm
Contact:

Re: Laser will not Fire

Post by lvmymp5 »

Found the problem it was the water protect circuit. The wires broke off when i tied it together. Thanks
Post Reply

Return to “D40/K40 small chinese CO2 laser machine”

Who is online

Users browsing this forum: No registered users and 18 guests