Z Table Dip Switch Settings

Post Reply
JerryLouisMartin
Posts: 32
Joined: Tue Mar 15, 2016 9:45 pm
Contact:

Z Table Dip Switch Settings

Post by JerryLouisMartin »

I need the Dipsswitch settings for the Z table!

6 DIPs


Zlm3020

Thanks!
jhuangupp
Posts: 9
Joined: Thu Mar 31, 2016 10:04 am
Contact:

Re: Z Table Dip Switch Settings

Post by jhuangupp »

Here is the setting from SW1 to SW6: On Off Off Off Off On.
If you think the motor is moving too fast or too big step, change the resolution to 3200 by changing SW4-SW6 to On On Off.
Hope that help.
J :D
JerryLouisMartin
Posts: 32
Joined: Tue Mar 15, 2016 9:45 pm
Contact:

Re: Z Table Dip Switch Settings

Post by JerryLouisMartin »

Dip settings are correct!

Need to verify wires?

Red, brown, yellow, orange go to?

My table beeps when I push up or down but will not move?

Thoughts?

Thanks
Tech_Marco
Posts: 4646
Joined: Mon Jun 15, 2009 3:00 pm
Contact:

Re: Z Table Dip Switch Settings

Post by Tech_Marco »

You may test the motor movement before putting it into the Z table. That way you can tell if connection is correct or not. Also, check the motor wire pair. Sometime the motor wire terminal mapping sequences is different . Example:
A+A-, B+B- or. A+ B+ ,A- B-

Marco
Post Reply

Return to “D40/K40 small chinese CO2 laser machine”

Who is online

Users browsing this forum: No registered users and 8 guests