2 posts • Page 1 of 1
got dsp hoked up and one of the stepper motors was wired wrong so i swapped a couple wires around and now it works fine but there is a faint high pitched whining noise coming from the stepper motor when it stops moving, sometimes i can move it a little and it will quit sometimes i have to move it into the limit switch to make it quiet down, it is not very loud just enough to drive a guy crazy im guessing like a dog whistle to a dog.... could i still have it wired wrong or would it not work right if that was the case.... thanks for any help
They do whine when on hold. I think it’s when they are between steps and micro stepping. I recently upgraded to hybrid closed loop motors. They are much quieter,smoother and also don’t stop with as much inertia as steppers so have far less vibration.
Who is online
Users browsing this forum: No registered users and 2 guests